Tradeline Polished Chrome H-Section Trim – 2420mm
A single Tradeline panel covers 1200mm. Most bathroom walls are wider than that, which means a joint somewhere along the run. The H-section trim is how you make that joint properly: both panel edges slot into either side of an H-shaped profile, giving a flush, sealed seam that holds the two boards in plane and keeps water out of the join.
Where you'll use it
- Joining two square edge panels on the same wall
- Any wall run wider than a single 1200mm panel
- Where a full-height and half-width panel meet
Product Details
| Brand | Tradeline |
| Type | H-Section Trim |
| Finish | Polished Chrome |
| Length | 2420mm — matches full panel height |
| Panel Compatibility | 11mm |
| Material | PVC |
Square edge only
H-section trims are for square edge panels. Tongue & groove panels slot directly into one another and do not need an H-section — that is the point of the T&G profile. If you are fitting T&G panels you will still need end caps and corner trims, but not this.
Fitting notes
- Seat the first panel, slide the H-section onto its edge, then bring the second panel in
- Seal inside both channels before seating each panel
- Check the run is plumb before committing — an H-section joint fixes the position of everything after it
- Leave any protective film on until the job is finished
Also available in
Satin silver, black and white.
Complete the Range
Pair with the polished chrome end cap, internal corner and external corner trims, plus panel adhesive and Topseal colour-match sealant. Browse the full Tradeline range.